Actions
Forum Thread Details
  • Replies 3 replies
  • Subscribers 168 subscribers
  • Views 362 views
  • Users 0 members are here
Related

Elongated hole

Former Member

Hi,

I'm designing a circuit that requires a long thin slot (6x1 mm) in a pad for

a relay terminal, has anyone come up with a solution for this?

 

Thanks,

Rob

 

 

 

Parents

  • Morten Leikvoll wrote on Mon, 14 December 2009 04:04

    If you use milling layer on plated holes,

     

    Note that whether internally routed slots are plated depends on the fab

    process, and you will get different results with different manufacturers or

    will have to pay extra to get what you want.

     

    Quote:

    take care if you use fill's or

    power layers somewhere between upper and lower layer. If you have that,

     

    either make sure it doesnt fill under the plating, or tell the

    manufacturer

    to make sure the plating doesnt make shorts.

     

    Or just set up the DRC rules properly in the first place so that there is

    clearance between planes and board edges.

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Reply

  • Morten Leikvoll wrote on Mon, 14 December 2009 04:04

    If you use milling layer on plated holes,

     

    Note that whether internally routed slots are plated depends on the fab

    process, and you will get different results with different manufacturers or

    will have to pay extra to get what you want.

     

    Quote:

    take care if you use fill's or

    power layers somewhere between upper and lower layer. If you have that,

     

    either make sure it doesnt fill under the plating, or tell the

    manufacturer

    to make sure the plating doesnt make shorts.

     

    Or just set up the DRC rules properly in the first place so that there is

    clearance between planes and board edges.

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Children
No Data