After duplicating a circuit many times (12), I am working on cleaning up
the inconsistencies (thank you Ing. J.M. Rafetseder for your Dec 7th
post on circuit duplication!).
At this point, the inconsistencies that remain are board trace
related. There are a few common bus signals that are connected in the
schematic, but no traces were routed from the board pads prior to
duplication. To make the schematic and board consistent, the board
signal needs to be renamed the same as the schematic, but I am unable to
click and highlight on the pad with NAME, as there are no air wires
coming from the pad.
How can the signal on the board pad, with no air wires or connected
trace be renamed?
The alternative is to ignore the inconsistencies, and the overlap board
errors when connecting the pad with the appropriate trace???
Thanks
KR
