Actions
Forum Thread Details
  • Replies 16 replies
  • Subscribers 173 subscribers
  • Views 720 views
  • Users 0 members are here
Related

Design rule screen in 5.7.0

autodeskguest

The design rule screen is missing the "Save As" and "Load" buttons, at

least I cannot find them nor any way to save the file to a new name.

The screen shown on page 131 of the manual shows them, but danged if I

can get them to show up.

--

John Bachman, W1JGB

AnaTek Corporation

 

Parents

  • John Bachman wrote on Sat, 16 January 2010 12:50

    It would also be quicker if you answered the question rather than

    telling us what you might do in my situation.

     

    You wanted to know if you could get the different DRC screen that I showed

    by running DRC in the board editor as apposed to wherever you were running

    it.  The point was that you could have and should have simply tried it.  It

    would have taken a few seconds.

     

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Reply

  • John Bachman wrote on Sat, 16 January 2010 12:50

    It would also be quicker if you answered the question rather than

    telling us what you might do in my situation.

     

    You wanted to know if you could get the different DRC screen that I showed

    by running DRC in the board editor as apposed to wherever you were running

    it.  The point was that you could have and should have simply tried it.  It

    would have taken a few seconds.

     

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Children
  • in reply to autodeskguest

     

    "Olin Lathrop" <eagle@embedinc.com> wrote in message

    news:hitct6$tdd$1@cheetah.cadsoft.de...

    John Bachman wrote on Sat, 16 January 2010 12:50

    It would also be quicker if you answered the question rather than telling

    us what you might do in my situation.

     

    You wanted to know if you could get the different DRC screen that I showed

    by running DRC in the board editor as apposed to wherever you were running

    it.  The point was that you could have and should have simply tried it.

    It

    would have taken a few seconds.

     

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

    Olin,

     

    You are obviously a very experienced engineer and have tons of knowledge.

    But why on earth do you insist on being so extremely rude on this forum?

     

    I just do not understand the need to be that way.  If 'newbie' questions get

    on your nerves so terribly, maybe those are the ones you should pass up and

    let somebody else answer.

     

    Terri