How do I connect a circle to a NET?
I want to draw a circle and connect that circle to ground.
The arc command, when trying to make a circle is not as accurate as the
circle command.
Say I want to use the arc command to create a circle with a radius of 9.5mm
centered at (20mm,20mm)
My calculation for creating the circle using the arc command are (20,29.5)
to (20.17,29.5) Curve = -359.
If you try it in eagle the center is off.
"Gary Gofstein" <nospam@use.forum.net> wrote in message
news:hqnvjd$9gu$1@cheetah.cadsoft.de...
On 4/21/2010 3:35 PM, Dang Tran wrote:
If I click on NAME command and then click the circle nothing happens.I dont see a dialog to enter in the name. "Gary Gofstein"<nospam@use.forum.net> wrote in messagenews:hqnpor$iqr$2@cheetah.cadsoft.de...
If I click on NAME command and then click the circle nothing happens.
I dont see a dialog to enter in the name.
"Gary Gofstein"<nospam@use.forum.net> wrote in message
news:hqnpor$iqr$2@cheetah.cadsoft.de...
On 4/21/2010 12:07 PM, Dang Tran wrote:
How do I connect a circle to a NET?I want to draw a circle and connect that circle to ground.
use the NAME command to name it to the net it belongs to. it must be drawnin a copper layer.
use the NAME command to name it to the net it belongs to. it must be
drawn
in a copper layer.
yup, I get the same. but it works for arcs so just make it out of one or two arcs.
yup, I get the same. but it works for arcs so just make it out of one or
two arcs.
