How do I connect a circle to a NET?
I want to draw a circle and connect that circle to ground.
Gary Gofstein thanks for the answer the half circles worked for me.
"Tilmann Reh" <usenet2007nospam@autometer.de> wrote in message
news:hqopjb$t2d$2@cheetah.cadsoft.de...
Gary Gofstein schrieb:
just make 2 semicircles and overlap them. this is a good use for theCOPY command ( which really duplicates objects). i don't think the 2nd coordinate is a point that is drawn, it is justused to define the diameter and that leads to an error since you don'thave the correct diameter. i can't offer you a better answer since I usev4 which is slightly different but I can do it with semicircles exactly.watch out for grid settings.
just make 2 semicircles and overlap them. this is a good use for the
COPY command ( which really duplicates objects).
i don't think the 2nd coordinate is a point that is drawn, it is just
used to define the diameter and that leads to an error since you don't
have the correct diameter. i can't offer you a better answer since I use
v4 which is slightly different but I can do it with semicircles exactly.
watch out for grid settings.
With V5, this is the same. A CIRCLE can't have a signal name, but ARCs can. So the correct solutionto this is drawing to half circles. (BTDT.) Tilmann
With V5, this is the same.
A CIRCLE can't have a signal name, but ARCs can. So the correct solution
to this is drawing to half circles. (BTDT.)
Tilmann
