Library with VTI SCA100T Part?

Am 21.01.2012 19:52, schrieb Mike Berry:

Hello,

 

I'm looking for a library file that includes the VTI  SCA100T-D02 inclinometer chip.  The data sheets don't even state which package it is.  It is a MEMS part.

 

I have designed my own parts using Eagle but aren't very good at it so I thought I would start here.

 

Thanks,

 

Mike Berry, Colorado

 

Section 3.2 of datasheet contains the footprint & measurements.

IMO sparkfun has a eagle library including this device.

--

Mit freundlichen Grüßen / With best regards

Joern Paschedag

I downloaded the SparkFun Eagle libraries for Eagle 6.0.  In the "Sparkfun-Sensors.lib" file is a VTI section with the single SCA300 part in it.

What am I missing?  Again I'm looking for the SCA100T part.  Any URL links would help.  Many thanks in advance.

mcb

I downloaded the SparkFun Eagle libraries for Eagle 6.0.  In the "Sparkfun-Sensors.lib" file is a VTI section with the single SCA300 part in it.

What am I missing?  Again I'm looking for the SCA100T part.  Any URL links would help.  Many thanks in advance.

mcb

I'm in business, thanks!  You soon are overwhelmed on projects if you have to spend time on every little piece.  Imagine building a house if the first thing you had to do is build a hammer.

mcb

Am 23.01.2012 16:05, schrieb Mike Berry:

I see no attached file but then I'm new to this.  My email is mcb theATthing ironxfer dt com if that works.  mcb

 

The file is attached in Warren Brayshaw. Unfortunately the link between

element14 and the other groups does not work correctly. If you don't

want the newsgroup check at eagle central

ca.http://www.eaglecentral.ca/forums/

--

Mit freundlichen Grüßen / With best regards

Joern Paschedag

I see no attached file but then I'm new to this.  My email is mcb theATthing ironxfer dt com if that works.  mcb

Am 22.01.2012 20:56, schrieb Warren Brayshaw:

The Sparkfun v5 libraries have the SCA1000 device that looks to be exactly

what you need.

I have extracted it and attached it here to make it simple for you. It will

likely convert to v6 if you use it.

You need to check to your satisfaction that it is exactly what you require

and the footprint is accurate.

 

Library devices do not get much simpler than this. Do the Sparkfun tutorial

on creating library parts and you will never have to ask for a part again.

 

>

HTH

Warren

 

>

Watch out for sparkfun libraries. They contain tons of additional layers

which can spoil your libraries if just integrate the device. One can see

the layers after using "set used_layers all"(Enter) in the command line.

Use this command in package & device.

--

Mit freundlichen Grüßen / With best regards

Joern Paschedag

The Sparkfun v5 libraries have the SCA1000 device that looks to be exactly

what you need.

I have extracted it and attached it here to make it simple for you. It will

likely convert to v6 if you use it.

You need to check to your satisfaction that it is exactly what you require

and the footprint is accurate.

Library devices do not get much simpler than this. Do the Sparkfun tutorial

on creating library parts and you will never have to ask for a part again.

HTH

Warren 

--

Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.