Thanks, I appreciate the guidance 
I believe the right approach would be to extend bottom side traces in the
affected area and add a pad. Then go to the top side, ripup the
appropriate connection and re-route to the new bottom side pad...
If this is incorrect in theory, let me know, otherwise I will try this
approach, thanks.
Gordon
--
Browser access to CadSoft Support Forums at http://www.eaglecentral.ca
Thanks, I appreciate the guidance
I believe the right approach would be to extend bottom side traces in the
affected area and add a pad. Then go to the top side, ripup the
appropriate connection and re-route to the new bottom side pad...
If this is incorrect in theory, let me know, otherwise I will try this
approach, thanks.
Gordon
--
Browser access to CadSoft Support Forums at http://www.eaglecentral.ca
