Actions
Forum Thread Details
  • Replies 2 replies
  • Subscribers 188 subscribers
  • Views 278 views
  • Users 0 members are here
Related

Schematic and Board Consistence

e14 Contributor

Hello,

 

how it can be possible, in the schematic a net has the name "+12V" and in the board i have two nets names (+12V and n$7).

I had already try run the ERC, and the report was, Board and Schematic are consistent.

 

I´m using the Eagle version 5.10.0

 

Regards.

NG

Parents

  • Most likely, you have a unconnected net in your schematics. It may look

    connected, but isnt. Using show for the netnames in brd or sch editor will

    show you the nets (show n$7 will show what's not connected). If you move a

    wire to a device pin, it will not connect. You need to move a device to the

    pin or draw the net to the pin. Could also be grid issues... A good way to

    check for net-device connection is to try tomove the device and see if the

    nets follow.

     

     

    "Nelson Goncalves" <communitymanager@premierfarnell.com> wrote in message

    news:1667427299.2461314259247044.JavaMail.jive@flmspu-csapp-02.premierfarnell.com...

    Hello,

     

    how it can be possible, in the schematic a net has the name "+12V" and in

    the board i have two nets names (+12V and n$7).

    I had already try run the ERC, and the report was, Board and Schematic are

    consistent.

     

    I´m using the Eagle version 5.10.0

     

    Regards.

    NG

     

     

     

     

Reply

  • Most likely, you have a unconnected net in your schematics. It may look

    connected, but isnt. Using show for the netnames in brd or sch editor will

    show you the nets (show n$7 will show what's not connected). If you move a

    wire to a device pin, it will not connect. You need to move a device to the

    pin or draw the net to the pin. Could also be grid issues... A good way to

    check for net-device connection is to try tomove the device and see if the

    nets follow.

     

     

    "Nelson Goncalves" <communitymanager@premierfarnell.com> wrote in message

    news:1667427299.2461314259247044.JavaMail.jive@flmspu-csapp-02.premierfarnell.com...

    Hello,

     

    how it can be possible, in the schematic a net has the name "+12V" and in

    the board i have two nets names (+12V and n$7).

    I had already try run the ERC, and the report was, Board and Schematic are

    consistent.

     

    I´m using the Eagle version 5.10.0

     

    Regards.

    NG

     

     

     

     

Children