Say I have 10 parts & all the airwires have been routed, so ideally
everything is done.
However, I want to add some additional copper paths, say from the input lug
terminal to the output lug terminal (to give it TWO beefy parallel
paths--assume there is not room for 1 massive path)...or perhaps from R2 to
R3 to provide an extra current path for high current. These do NOT violate
the schematic. However, when clicking on the component pin, Eagle just
beeps--apparently to tell me that pin is already finished.
How can I override a "finished" pin to add an alternative rotue?
I don't want pours or polygons, just extra parallel traces (that might take
various geometrical paths).
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
