Actions
Forum Thread Details
  • Replies 36 replies
  • Subscribers 190 subscribers
  • Views 4691 views
  • Users 0 members are here
Related

in V6.0.0 manual routing got really hard

e14 Contributor

somethings changed, when i manually route and click on the destination pad, if i dont click dead center now... im left with tiny tiny airwires

5.11 didnt do this... i have messed with alot of settings, nothing seems to help

Parents

  • This doesn't limit to snapping to pads but into "stubs" too. If I have a

    track that connects pin A to pin B and I ripup a part of that wire, and

    then start to draw net from pad A into the stub, eagle doesn't snap to the

    stub. It took several ratsnest commands to get eagle to snap into the stub

    rather than into grid. I.E. for some reason eagle wants to snap into grid

    and not that stub cap that's not on the grid. In 5.11 this was never an

    issue. In 6.0.0 random ratsnest commands seem to fix this momentarily.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • This doesn't limit to snapping to pads but into "stubs" too. If I have a

    track that connects pin A to pin B and I ripup a part of that wire, and

    then start to draw net from pad A into the stub, eagle doesn't snap to the

    stub. It took several ratsnest commands to get eagle to snap into the stub

    rather than into grid. I.E. for some reason eagle wants to snap into grid

    and not that stub cap that's not on the grid. In 5.11 this was never an

    issue. In 6.0.0 random ratsnest commands seem to fix this momentarily.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
No Data