Actions
Forum Thread Details
  • Replies 26 replies
  • Subscribers 181 subscribers
  • Views 2700 views
  • Users 0 members are here
Related

Eurocircuits and V6 .brd files

Former Member

Just mailed two designs to Eurocircuits this afternoon made by Eagle V6.

Received a reject as 'does not look to be a valid .brd file'.

I wonder if they know about the changes in V6?

 

Robert

 

Parents

  • Robert wrote on Sat, 14 January 2012 11:33

    I see that layer 3 (in Eagle), which became .L15 in the Gerber files,

    was completely wrong, no wiring. This is probably because the quad

    layer

    board was defined in Eagle as (123*16).

     

    That sounds like you used layers 1, 2, 3 and 16, but wrote out layers 1, 2,

    15, and 16.  I always use consecutive layers from one except that the

    bottom layer is 16 to avoid any confusion.  Still, that should have been

    easily spotted when previewing the gerber files, so I still don't see how

    that could have happened.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • Robert wrote on Sat, 14 January 2012 11:33

    I see that layer 3 (in Eagle), which became .L15 in the Gerber files,

    was completely wrong, no wiring. This is probably because the quad

    layer

    board was defined in Eagle as (123*16).

     

    That sounds like you used layers 1, 2, 3 and 16, but wrote out layers 1, 2,

    15, and 16.  I always use consecutive layers from one except that the

    bottom layer is 16 to avoid any confusion.  Still, that should have been

    easily spotted when previewing the gerber files, so I still don't see how

    that could have happened.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
No Data