Hi,
I have a FET with the pad layout shown in the attached drawing. I've tried
a few things but can't get past the "Package ... contains an invalid
polygon."
First I tried having 4 pads all connected with a polygon in the shape of an
"H". That didn't work.
Next I tried a single pad with the "H" creating the other 3 pads with the
polygon. That did't work. In addition, if I make the polygon width too
large, it doesn't fit, too small, Eagle complains, and anything in the
middle leaves the corners of the other 3 pads rounded.
Next I tried a single pad but creating the pad with wires. This doesn't
work either and I have the same problem with the rounded corners.
Finally I tried a single pad and making the "H" with overlapping rectangles
on the top side. And guess what? That didn't work either.
What is even more confusing is for the last 2 attempts there aren't even
any polygons in the package (and I have only this one library turned on so
there aren't any other conflicting packages).
I'm baffled as to how to do this. Any ideas?
Thanks,
Dave
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
 |
