Unrouted

Is there a command to highlight unrouted signals on a board besides the layer on/off of unrouted signals? Dense boards make finding unrouted wires difficult to see.

Thanks,

Bob Moreno

skyflyrr over 14 years ago in reply to e14 Contributor

Thanks for the tip. Any way to just highlight without cursor use, so that no routes are started, just to see where one stands as far as routing goes?

Thanks again for the tip.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
e14 Contributor over 14 years ago

On 11.07.2012 22:04, Bob Moreno wrote:
Is there a command to highlight unrouted signals on a board besides
the layer on/off of unrouted signals? Dense boards make finding
unrouted wires difficult to see.

Thanks,

Bob Moreno

Go to Options/Set/Misc and set the Catch factor to 100%.
Activate ROUTE and click into the drawing. The airwire next to the
mouse cursor catches the cursor........

--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel