Actions
Forum Thread Details
  • Replies 1 reply
  • Subscribers 188 subscribers
  • Views 349 views
  • Users 0 members are here
Related

Help with PCB Copper Pouring

e14 Contributor

Hello,

 

I am new to Eagle and having trouble with copper pouring. I use CAM

Processor to make Gerber file, but I want only routes to remain after

etching and rest of the copper to disappear!

 

Please help!

 

thanks in advance.

 

Haris

--

Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

 

Parents

  • On 7/13/2012 7:30 AM, Haris wrote:

    Hello,

     

    I am new to Eagle and having trouble with copper pouring. I use CAM

    Processor to make Gerber file, but I want only routes to remain after

    etching and rest of the copper to disappear!

     

    Please help!

     

    thanks in advance.

     

    Haris

     

         Not sure exactly what your question is?   If you don't create any

    polygons and you don't define any of the layers as power planes then you

    should only get traces, pads, and the annular rings around

    through-holes.  Obviously you should load up your gerber files in your

    favorite gerb viewer and make sure that the CAM processor has done what

    you want.....preferable before sending the board to fab.

     

    Regards,

    Jim

     

     

Reply

  • On 7/13/2012 7:30 AM, Haris wrote:

    Hello,

     

    I am new to Eagle and having trouble with copper pouring. I use CAM

    Processor to make Gerber file, but I want only routes to remain after

    etching and rest of the copper to disappear!

     

    Please help!

     

    thanks in advance.

     

    Haris

     

         Not sure exactly what your question is?   If you don't create any

    polygons and you don't define any of the layers as power planes then you

    should only get traces, pads, and the annular rings around

    through-holes.  Obviously you should load up your gerber files in your

    favorite gerb viewer and make sure that the CAM processor has done what

    you want.....preferable before sending the board to fab.

     

    Regards,

    Jim

     

     

Children
No Data