Upgraded to Eagle 6.2. Now can't move components on PCB created in 6.1.

Upgraded to Eagle 6.2. Now I can't move components on a PCB created in 6.1. I can move traces, and even designators, but I cannot get hold of the components. I can't even get their properties. Any ideas?

Thanks.

kikiorg over 9 years ago in reply to clem57

Yep! Me too! The layers in the Arduino Eagle file are many and cryptic.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
clem57 over 10 years ago in reply to jlaskowski

Agreed.
Clem
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jlaskowski over 10 years ago in reply to rickford66

You never know when a post of your own boo-boo will help someone else...this helped just now, four years later!
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
rickford66 over 13 years ago

Nevermind. I didn't realize I turned off the origins layer.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
autodeskguest over 13 years ago

On 9/27/2012 4:06 PM, rickford66 wrote:
Upgraded to Eagle 6.2. Now I can't move components on a PCB created in 6.1. I can move traces, and even designators, but I cannot get hold of the components. I can't even get their properties. Any ideas?
Thanks.

Hi Rickford,

Make sure your tOrigins and bOrigins layers are on, they contain all of
the snap points and without them you can't move anything.

hth,
Jorge Garcia
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel