Upgraded to Eagle 6.2. Now can't move components on PCB created in 6.1.

Upgraded to Eagle 6.2. Now I can't move components on a PCB created in 6.1. I can move traces, and even designators, but I cannot get hold of the components. I can't even get their properties. Any ideas?

Thanks.

Top Replies

autodeskguest over 13 years ago +1

On 9/27/2012 4:06 PM, rickford66 wrote: Upgraded to Eagle 6.2. Now I can't move components on a PCB created in 6.1. I can move traces, and even designators, but I cannot get hold of the components. I can…
jlaskowski over 10 years ago in reply to rickford66 +1

You never know when a post of your own boo-boo will help someone else...this helped just now, four years later!

Parents

rickford66 over 13 years ago

Nevermind. I didn't realize I turned off the origins layer.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

rickford66 over 13 years ago

Nevermind. I didn't realize I turned off the origins layer.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

jlaskowski over 10 years ago in reply to rickford66

You never know when a post of your own boo-boo will help someone else...this helped just now, four years later!
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
clem57 over 10 years ago in reply to jlaskowski

Agreed.
Clem
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
kikiorg over 9 years ago in reply to clem57

Yep! Me too! The layers in the Arduino Eagle file are many and cryptic.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel