I am missing a possibility to enter an offset or zero point to the grid I selected, With the different Pitches and the mix of inches and metric I often have to switch and it would realy help if I could switch the offset to.
Kind regards
John
I am missing a possibility to enter an offset or zero point to the grid I selected, With the different Pitches and the mix of inches and metric I often have to switch and it would realy help if I could switch the offset to.
Kind regards
John
I would very much like to second that.
Most component and mechanical drawings are dimentioned with relational mesurements.
I finde my self sitting with my 1987 HP42S RPN calculator all the time witch in stupid since
i am sitting infront of a xxx gigiflops computer...
It is not called "computer aided design" for nothing 
For me it would be sufficiant if the mark command could be extended by being offset for the "alt" grid when
eg CTRL and ALT key is pressed to be able to place, route and so on in this cordinate system.
Keep up the good work.
Asbjørn Holland Chrsitensen
Musalk
Eagle user for 10 years
I would very much like to second that.
Most component and mechanical drawings are dimentioned with relational mesurements.
I finde my self sitting with my 1987 HP42S RPN calculator all the time witch in stupid since
i am sitting infront of a xxx gigiflops computer...
It is not called "computer aided design" for nothing
For me it would be sufficiant if the mark command could be extended by being offset for the "alt" grid when
eg CTRL and ALT key is pressed to be able to place, route and so on in this cordinate system.
Keep up the good work.
Asbjørn Holland Chrsitensen
Musalk
Eagle user for 10 years
