I have a few wires (nets) that I'd like to give names to (such as Vbatt,
PWM_CTL, etc)....then other wires on the same page are given the same names
to establish connectivity between them without a lot of wire clutter. In
the past, I've added little arrow symbols (as components), but this time
I'd like to name the wires directly for less clutter. Just have the desired
name setting alongside a long wire.
I see that I can do an info on a wire (net) & edit the netname, but the
name is not shown on the schematic. Am I missing something? Or maybe you
are forced to add arrow symbols (components).
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
