Actions
Forum Thread Details
  • Replies 6 replies
  • Subscribers 179 subscribers
  • Views 1399 views
  • Users 0 members are here
Related

need bare copper

e14candies

I defined a reactangle  & also a rather strange shape polygon on layer 1

(with 100 mils clearance.  They both show up as red, just fine.  However,

since these are heat sinks, I do not want them to be covered with anything

such as soldermask..I want bare coipper here (or perhaps with solder

reflow. How do you specify this when drawing the polygon or rectanlge?

--

Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

 

Parents

  • ..is there an easy way to copy this exactly on the mentioned layer...my

    polygon has many vertices.

     

    so how can you get the exact same polygon on different layers?  Is there a

    way to copy it from one layer to another?

     

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

  • in reply to e14candies

    Hoyt wrote:

    ..is there an easy way to copy this exactly on the mentioned

    layer...my polygon has many vertices.

     

    so how can you get the exact same polygon on different layers?  Is

    there a way to copy it from one layer to another?

     

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where

    the CadSoft EAGLE community meets.

     

    Hi

    There are two ULPs that can assist here. Check out:

    copy-layer-to-any-layer.ulp

    copy-wire-to-solder-mask.ulp

     

    Eagle wont copy from a signal layer to a non signal layer so these ULPs get

    around that by analysing, say, your top layer and rebuilding it on a non

    signal layer.

     

    Warren

     

     

    --

    Viewed / responded via the newsgroup at

    news.cadsoft.de

     

     

     

Reply
  • in reply to e14candies

    Hoyt wrote:

    ..is there an easy way to copy this exactly on the mentioned

    layer...my polygon has many vertices.

     

    so how can you get the exact same polygon on different layers?  Is

    there a way to copy it from one layer to another?

     

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where

    the CadSoft EAGLE community meets.

     

    Hi

    There are two ULPs that can assist here. Check out:

    copy-layer-to-any-layer.ulp

    copy-wire-to-solder-mask.ulp

     

    Eagle wont copy from a signal layer to a non signal layer so these ULPs get

    around that by analysing, say, your top layer and rebuilding it on a non

    signal layer.

     

    Warren

     

     

    --

    Viewed / responded via the newsgroup at

    news.cadsoft.de

     

     

     

Children
No Data