When I try to export my eagle schematic to LTSpice IV a windows box pops up
and displays "LTspiceIV (scad3.exe) not found."
Where do I configure Eagle-6.4.0 to my LTspice IV directory.
Is LTspice IV interface is block because I'm using the free version of
Eagle?
Dale Farmer wrote on Tue, 18 June 2013 15:56
When I try to export my eagle schematic to LTSpice IV a windows box
pops up
and displays "LTspiceIV (scad3.exe) not found."
Where do I configure Eagle-6.4.0 to my LTspice IV directory.
Hi. If you still haven't fixed that, here is how I did it this morning.
In the EAGLE control panel find the "ltspice.ulp" (under User Language
Programs), right click and open it.
In the editor, find the string "rootpath" (it should be at line 4082) and
add inside the {} (just after the { is fine), the path of your LTspiceIV
folder, between "" and followed by a comma.
Example:
Original line 4082
string rootpath[] = { "C:/Programme/", "C:/Program files (x86)/",
"C:/Program files/", "D:/Program files (x86)/", "D:/Program files/" };
Your LTspiceIV folder
C:\Progs\LTC\LTspiceIV\
New line 4082
string rootpath[] = { "C:/Progs/LTC/", "C:/Programme/", "C:/Program files
(x86)/", "C:/Program files/", "D:/Program files (x86)/", "D:/Program
files/" };
This is a "brute force" solution and has not been fully tested, I hope thai
it works and that the Techical Support will fix it in a better way.
Hope it helps. 
Luigi Giovannelli
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
Dale Farmer wrote on Tue, 18 June 2013 15:56
When I try to export my eagle schematic to LTSpice IV a windows box
pops up
and displays "LTspiceIV (scad3.exe) not found."
Where do I configure Eagle-6.4.0 to my LTspice IV directory.
Hi. If you still haven't fixed that, here is how I did it this morning.
In the EAGLE control panel find the "ltspice.ulp" (under User Language
Programs), right click and open it.
In the editor, find the string "rootpath" (it should be at line 4082) and
add inside the {} (just after the { is fine), the path of your LTspiceIV
folder, between "" and followed by a comma.
Example:
Original line 4082
string rootpath[] = { "C:/Programme/", "C:/Program files (x86)/",
"C:/Program files/", "D:/Program files (x86)/", "D:/Program files/" };
Your LTspiceIV folder
C:\Progs\LTC\LTspiceIV\
New line 4082
string rootpath[] = { "C:/Progs/LTC/", "C:/Programme/", "C:/Program files
(x86)/", "C:/Program files/", "D:/Program files (x86)/", "D:/Program
files/" };
This is a "brute force" solution and has not been fully tested, I hope thai
it works and that the Techical Support will fix it in a better way.
Hope it helps.
Luigi Giovannelli
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
