I have a board full of parts, no problem with the schematic or layout.
However, I also have a few wires that get soldered to the board in random
locations, say Fred here & Sam there, they solder to some vias (NOT
connectors)...they run some zigzag traces then leave the board by wire at
different vias. These traces do not connect to any components.
How do I show these via (incoming)-to-via(outgoing) wires on my schematic
so they'll show as required traces on my board editor?
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
