Actions
Forum Thread Details
  • Replies 6 replies
  • Subscribers 189 subscribers
  • Views 686 views
  • Users 0 members are here
Related

Pad with complex hole

eugeny

Hello, connector has its through-hole chassis pin 2.4 x 1 mm size, what is the right way to create pad for it?

SMD pad with holes give errors, hole without pad leaves space with no copper around the hole (0.2 mm clearance is required by PCB manufacturer).

Please advise.

Parents

  • You could triple check you layout & just bluntly approve this error & move

    ahead with the work. 

     

    Or, you might need to adjust your min allowable "dimensions" in the various

    DRC configuration tabs  (PCB, TOOLS==>DRC).  Or set up a special class for

    this net.  I'm sure others will weigh in with even better proposals.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • You could triple check you layout & just bluntly approve this error & move

    ahead with the work. 

     

    Or, you might need to adjust your min allowable "dimensions" in the various

    DRC configuration tabs  (PCB, TOOLS==>DRC).  Or set up a special class for

    this net.  I'm sure others will weigh in with even better proposals.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
No Data