I have created a Device to hold a AA battery in place using two through-hole clips spaced apart. I did this so I could move the battery clips freely without having to verify their spacing. When generating a BOM, I'd like the single Device to be listed as two of these clips. And I also need the center for each clip for a pnp machine, rather than the center for the single device I created. Is there a way to automate this?
Basically, is there a way to create a Device consisting of multiple other Devices?
The clips I used are BK-92 clips linked below:
BK-92 MPD (Memory Protection Devices) | Battery Products | DigiKey
Thanks