I need to match the impedance (50ohm) of an active GPS antenna, from the
connector on the board. How can I calculate the size and width of the strip
to match? Is there any way to do this on Eagle ?
Thiago
I need to match the impedance (50ohm) of an active GPS antenna, from the
connector on the board. How can I calculate the size and width of the strip
to match? Is there any way to do this on Eagle ?
Thiago
The name of the company is Agilent not Aglient as I wrote . Here is example of the microstrip calculation:
Petr
"Petr Pastor" <petr@pastor.cz> wrote in message news:fos36a$kjc$1@cheetah.cadsoft.de...
There is good free sw caled AppCAD from Aglient technologies.
Try this and you'll be satisfied.
Petr
"Thiago Henrique" <thiago_hr@yahoo.com.br> wrote in message
news:foqvbh$ql7$1@cheetah.cadsoft.de...
I need to match the impedance (50ohm) of an active GPS antenna, from the
connector on the board. How can I calculate the size and width of the
strip to match? Is there any way to do this on Eagle ?
Thiago
 |
