Actions
Forum Thread Details
  • Replies 5 replies
  • Subscribers 177 subscribers
  • Views 1719 views
  • Users 0 members are here
Related

Analog and digital ground; how to connect?

autodeskguest

Hi,

 

I have a circuit which uses an analog and digital ground.

 

These grounds must be connected at one point. How can i achieve this?

 

Note:

I created a dgnd and an agnd ; i connected these two symbols in the

schematic; it results in a net of agnd or dgnd; The electric rule check

results in an ERROR: .... overwritten with more than one signal .

 

 

Regards,

 

Johan

 

 

Parents

  • Marco Trapanese wrote:

    Familie Maas ha scritto:

     

    I have a circuit which uses an analog and digital ground.

     

    These grounds must be connected at one point. How can i achieve this?

     

    Note:

    I created a dgnd and an agnd ; i connected these two symbols in the

    schematic; it results in a net of agnd or dgnd; The electric rule

    check results in an ERROR: .... overwritten with more than one signal .

     

    Try supply-dummy.lbr

     

    Marco / iw2nzm

     

    Can't see that on cadsoft's site

     

Reply

  • Marco Trapanese wrote:

    Familie Maas ha scritto:

     

    I have a circuit which uses an analog and digital ground.

     

    These grounds must be connected at one point. How can i achieve this?

     

    Note:

    I created a dgnd and an agnd ; i connected these two symbols in the

    schematic; it results in a net of agnd or dgnd; The electric rule

    check results in an ERROR: .... overwritten with more than one signal .

     

    Try supply-dummy.lbr

     

    Marco / iw2nzm

     

    Can't see that on cadsoft's site

     

Children
No Data