Actions
Forum Thread Details
  • State Verified Answer
  • Replies 4 replies
  • Subscribers 166 subscribers
  • Views 607 views
  • Users 0 members are here
Related

CAM process hanging on"printing aperture D10"

dandeurloo

I am trying to print my first 4 layer PCB.  I am trying to run a CAM process for printing my Gerbers.  The CAM process keeps hanging up on a screen that says "printing aperture D10".  Do these "printing aperture D's" typically take a long time to process?



Any ideas what might be the issue and how I can get these Gerbers created?


I am using EagleCAD 7.7

 

Thanks.

Parents Reply Children
  • 0 in reply to dandeurloo

    On 14/05/2020 17:39, Dan Deurloo wrote:

      Is there a preferred size of wire for creating polygons?

    Not a single value. The width parameter controls the narrowest fill you

    can achieve, and thus the smallest gap it can flood through. It also

    controls the width of the bridges across "thermal" isolation on PTH

    pads. Generally, you should go for the widest that doesn't cause you any

    problems with flood fill. That said, the corners are rounded to the

    width setting, too, so making it too wide "blurs" the shape.

     

  • 0 in reply to dandeurloo

    On 14.05.2020 18:39, Dan Deurloo wrote:

    Yes, this was it!  Thank you.  Is there a preferred size of wire for creating polygons?

     

    As Rob says..

    Remember the wire width requirement originates from the time when the

    fill actually happened with a round pen/aperture, and this is why inner

    and outer corner sharpness is limited to this pen diameter. If this pen

    is very thin (or 0, wich is converter to very very very thin in eagle),

    imagine the time it will take to fill it.

    Today's modern transfer tech does not have this limitation as the are

    very fine pitch pixel based. But modern tools support support converting

    the old stuff. I have been missing "flash" mode fills on Eagle for a

    long time. It would also make screen drawing a lot faster, wich you will

    notice when working with larger pcb's.