Actions
Forum Thread Details
  • Replies 4 replies
  • Subscribers 179 subscribers
  • Views 493 views
  • Users 0 members are here
Related

Polygon Error in EAGLE 5.0

Former Member

Hello all,

 

I'm trying EAGLE 5.0 Freeware and I'm getting an illegal polygon error and

I'm unable to generate the layer.  It's apparently an overlapping polygon,

but why am I able to generate the layer without an error in EAGLE 4.16?

 

Thanks,

 

Terri Miller

 

 

 

Parents

  • Terri Miller schrieb:

    Hello Richard,

     

    I've sent an email with files attached to the email address provided.

     

    Thanks!

     

    Terri

     

     

    Here in short my answer to Terri's problem:

     

    "The polygon contour of the polygon is not drawn proper enough.

      If you take a look at position (15.2 25.9) and move the

      polygon wire a little bit to the left it will be calculated.

      At this position the contour wire overlaps slightly and causes

      the error.

      In 4.16 it was not reported as a problem, this is correct.

      But there are lots of improvements and changes in the algorithm,

      so that this overlap causes an error message now.

      And to be honest, it should have been reported in 4.1, as well."

     

     

    --

    Mit freundlichen Gruessen / Best regards

    Richard Hammerl

      CadSoft Support -- hotline@cadsoft.de

      FAQ: http://www.cadsoft.de/faq.htm

     

Reply

  • Terri Miller schrieb:

    Hello Richard,

     

    I've sent an email with files attached to the email address provided.

     

    Thanks!

     

    Terri

     

     

    Here in short my answer to Terri's problem:

     

    "The polygon contour of the polygon is not drawn proper enough.

      If you take a look at position (15.2 25.9) and move the

      polygon wire a little bit to the left it will be calculated.

      At this position the contour wire overlaps slightly and causes

      the error.

      In 4.16 it was not reported as a problem, this is correct.

      But there are lots of improvements and changes in the algorithm,

      so that this overlap causes an error message now.

      And to be honest, it should have been reported in 4.1, as well."

     

     

    --

    Mit freundlichen Gruessen / Best regards

    Richard Hammerl

      CadSoft Support -- hotline@cadsoft.de

      FAQ: http://www.cadsoft.de/faq.htm

     

Children
No Data