In Eagle (v9.6.2), the routes fill the holes of my pads. hence when I want to print it, the pads are all black, no drill holes. What am I missing?
In Eagle (v9.6.2), the routes fill the holes of my pads. hence when I want to print it, the pads are all black, no drill holes. What am I missing?
Hi will.mendil
in the "OPTIONS" - "Settings" - "Miscellaneous" you must check the checkbox "show holes" .
-
Then in the printer settings you're right you must check in the checkbox "black" as well "solid".
The next:
You have problems with the distance between the pads and the distance to the edge of the board.
DRC settings: Either set the distances in the rules (but be careful with that values, too small distance values cannot be etched) or use smaller pads.
Best Regards
Gerald
---
Hi will.mendil
in the "OPTIONS" - "Settings" - "Miscellaneous" you must check the checkbox "show holes" .
-
Then in the printer settings you're right you must check in the checkbox "black" as well "solid".
The next:
You have problems with the distance between the pads and the distance to the edge of the board.
DRC settings: Either set the distances in the rules (but be careful with that values, too small distance values cannot be etched) or use smaller pads.
Best Regards
Gerald
---