Hi!
Is it possible to limit the autorouting to placing tracks in directions
multiples of 45 degrees only?
Regards,
Pedro
Hi everyone!
No help here? I cannot believe the autorouter is not prepared to meet
such a common procedure among PCB design...
Cheers,
Pedro Rodrigues wrote:
Hi! Is it possible to limit the autorouting to placing tracks in directions multiples of 45 degrees only? Regards,Pedro
On 06/03/08 17:31, Pedro Rodrigues wrote:
Hi! Is it possible to limit the autorouting to placing tracks in directions multiples of 45 degrees only?
The autorouter does lay tracks only in multiples of 45 degrees
(except possibly the last short piece inside a pad or smd in case
it is off grid).
Klaus Schmidinger
--
_______________________________________________________________
Klaus Schmidinger Phone: +49-8635-6989-10
CadSoft Computer GmbH Fax: +49-8635-6989-40
Hofmark 2 Email: kls@cadsoft.de
D-84568 Pleiskirchen, Germany URL: www.cadsoft.de
a quick check in v4.16, it seems to only autoroute in multiples of 45.
Indeed, now I notice it properly. I ran the DRC and it gave me a huge
list of angle errors, but now I realize they are all inside the pads.
Thanks a lot for the hint,
Klaus Schmidinger wrote:
Is it possible to limit the autorouting to placing tracks in
directions multiples of 45 degrees only?
The autorouter does lay tracks only in multiples of 45 degrees(except possibly the last short piece inside a pad or smd in caseit is off grid). Klaus Schmidinger
