Actions
Forum Thread Details
  • Replies 3 replies
  • Subscribers 179 subscribers
  • Views 374 views
  • Users 0 members are here
Related

Overlap Errors

rasteen

On running the DRC on a manually routed board I get overlap errors on all

signal connections to through hole and SMD pads.  The signal layers look

good to me, do I have a configuration error ? - Ron

 

 

 

Parents

  • Ron schrieb:

    Yes, I used Wire to route the board. My question now is with the exception

    of failing DRC will there be any difference in the board design than if I

    used the correct method using the SIGNAL command ? It would be a big job to

    reroute the entire board.

     

    Thanks - Ron Steen

     

     

     

    If the layout looks correct it is not a real problem. The

    wire is on the pad and so the copper connection is okay.

    But of course you ought to be very careful not to overlook

    relevant errors.

     

    --

    Mit freundlichen Gruessen / Best regards

    Richard Hammerl

      CadSoft Support -- hotline@cadsoft.de

      FAQ: http://www.cadsoft.de/faq.htm

     

Reply

  • Ron schrieb:

    Yes, I used Wire to route the board. My question now is with the exception

    of failing DRC will there be any difference in the board design than if I

    used the correct method using the SIGNAL command ? It would be a big job to

    reroute the entire board.

     

    Thanks - Ron Steen

     

     

     

    If the layout looks correct it is not a real problem. The

    wire is on the pad and so the copper connection is okay.

    But of course you ought to be very careful not to overlook

    relevant errors.

     

    --

    Mit freundlichen Gruessen / Best regards

    Richard Hammerl

      CadSoft Support -- hotline@cadsoft.de

      FAQ: http://www.cadsoft.de/faq.htm

     

Children
No Data