I created a header part in my custom library and discovered that the pads had too little space between them. I modified my footprint by decreasing the diameter of the pad and saved it. Went to my board layout and updated the library that the part is in. I used the Library menu tab, not the command line. The part footprint does not update. If I go back into the library and look at the part, the pad size is correct. But, I can’t get the new smaller pad size to appear on my board. Even if I add another header of the same part to the schematic, it comes out in layout as the original pad diameter, not the smaller one as it should. Thanks, David
