Is it possible to modify an SMT pad to look like the one attached? If so,
how is that done?
Thanks John,
Take a look at the pad again, it has (8) sides not (4).
-charlie
"John Giddy" <jgiddy@bigpond.net.au> wrote in message
news:g6gain$tsk$1@cheetah.cadsoft.de...
Charlie Van Dien wrote:
Someone please answer... "Charlie Van Dien" <vandien@bellsouth.net> wrote in message news:g6cvuu$5gt$1@cheetah.cadsoft.de...
Someone please answer...
"Charlie Van Dien" <vandien@bellsouth.net> wrote in message
news:g6cvuu$5gt$1@cheetah.cadsoft.de...
Is it possible to modify an SMT pad to look like the one attached? If so, how is that done?
Is it possible to modify an SMT pad to look like the one attached? If
so, how is that done?
Your picture just shows a plain rectangular pad. You can make such pads easily. In the package editor of the library place an SMD of any size and then use the CHANGE SMD command to alter the size. When you type that command you get a drop-down menu with the preset sizes listed, and at the bottom, a line with three dots. Choose this and you are given a window where you can insert the dimensions you require. Maximum value of either x or y is 0.516024"John G.
Your picture just shows a plain rectangular pad. You can make such pads
easily. In the package editor of the library place an SMD of any size and
then use the CHANGE SMD command to alter the size. When you type that
command you get a drop-down menu with the preset sizes listed, and at the
bottom, a line with three dots. Choose this and you are given a window
where you can insert the dimensions you require. Maximum value of either x
or y is 0.516024"
John G.
