IC doesn't show all of the pins on the schematic view.

Question

I found the part I needed in the part listing on Cadsoft Eagle. It shows the proper amount of pins on the board view but

doesn't have all of the connections needed on the schematic view. This is probably a noob question but either my googlefu is weak or

there isn't any info regarding this... or the question is so stupid nobody bothers to ask it.

Below are two example I found in the components list. Both are 16 pin monostable multivibrators but no all of the pins are listed on the schematic view.

robotonics · Accepted Answer

Ok a couple of pics...first one below show 8, 9,10,&11 connected GND symbol from SUPPLY1 library, also shown are VCC connections

Pic below is the board view with tracks routed....bit rough but you should get the idea..

It will become clearer as you get more experienced...need any more help just ask...