I almost finished a circuit; but there are some components which are not right placed on the grid. The same things appens for wire so that placea node is impossible.
How can i fix the position of component or wire on the grid?
I tried to modify the dimension of the grid but it was unuseful.
Thanks.
A very annoying problem...usually happens when you change the grid size after already adding components.
I am a practical person and find it best to either delete the board and start again, or change ALT to 'finest' in GRID display,and keep ALT held down when wiring so that you can get finer control of your cursor. 
On 21.04.2012 17:02, David Cotterill-Drew wrote:
A very annoying problem...usually happens when you change the grid size after already adding components.
I am a practical person and find it best to either delete the board and start again, or change ALT to 'finest' in GRID display,and keep ALT held down when wiring so that you can get finer control of your cursor.
Changing the grid in the layout editor has no effects on the already
placed objects.
If you have to change the position of an object, use CTRL + MOVE in
order to bring the component onto the current grid or change the
location via properties or you could also use MOVE with coordinates
in the command line, like MOVE U1 (2.3 7.15)
--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
On 21.04.2012 17:02, David Cotterill-Drew wrote:
A very annoying problem...usually happens when you change the grid size after already adding components.
I am a practical person and find it best to either delete the board and start again, or change ALT to 'finest' in GRID display,and keep ALT held down when wiring so that you can get finer control of your cursor.
Changing the grid in the layout editor has no effects on the already
placed objects.
If you have to change the position of an object, use CTRL + MOVE in
order to bring the component onto the current grid or change the
location via properties or you could also use MOVE with coordinates
in the command line, like MOVE U1 (2.3 7.15)
--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
