How to unfill a polygon after ratsnet

Question

Hi: Once you create a polygon for a ground plane, and after using Ratsnet, the polygon fills. How to get rid of the fill again (other than closing and opening the .brd again)? Thanks; Gus

e14 Contributor · Answer

On 7/29/2012 12:34 PM, Gus Sabina wrote:

Hi:

Once you create a polygon for a ground plane, and after using Ratsnet, the polygon fills. How to get rid of the fill again (other than closing and opening the .brd again)?

Thanks;
Gus

Hi Gus,

You can type:

RIPUP @;

Followed by enter in the EAGLE command line.This will return all of the

polygons to outline mode.

hth,

Jorge Garcia

autodeskguest · Answer

Am 09.09.2017 um 03:07 schrieb Scott Archer: to add... I find it very frustrating that the pour area re-fills every time I run ratsnest, and I have to ripup to hide it again. My solution was to add a keybinding (i used ctrl + D) and have the command run: RATSNEST; RIPUP @; This reroutes the airwires, then clears away the pour. Eagle 7.6.0 -- To view any images and attachments in this post, visit: https://www.element14.com/community/message/228497 One usually puts "set_polygon_ratsnest off" (on) on keys -- Mit freundlichen Grüßen / With best regards Joern Paschedag