If you look at the attached pdf file, it is a schematic, where the IC pins are not all connected explicitly with wires. However, the pins are still shown to make connections to the connectors. How can I achieve the same look and feel with Eagle Cad?
If you look at the attached pdf file, it is a schematic, where the IC pins are not all connected explicitly with wires. However, the pins are still shown to make connections to the connectors. How can I achieve the same look and feel with Eagle Cad?
Draw two nets. Then give them the same name.
Is that what you are after?
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
That helped me 50%. You helped me connect the signals, that's great. However, can I get the Text labels to correlate? Without text, it will be impossible to read the schematic without analysis in software. If you look at the PDF I attached in the original post, you see that the name of the chip pin is reflected over the net coming from the connector. I would like the name of the pin to appear in this way when I connect the signals.
It would be great to have this happen automatically instead of having to manually use the Text command for every signal on a 128-pin chip
That helped me 50%. You helped me connect the signals, that's great. However, can I get the Text labels to correlate? Without text, it will be impossible to read the schematic without analysis in software. If you look at the PDF I attached in the original post, you see that the name of the chip pin is reflected over the net coming from the connector. I would like the name of the pin to appear in this way when I connect the signals.
It would be great to have this happen automatically instead of having to manually use the Text command for every signal on a 128-pin chip