How can I select components booth in schematic and layout at the same time?

Question

I've seen and used this practical feature in an other designer system. However if I select let's say IC1 in schematic and move to the layout there is no selection for IC1 at all...

Is there any solution for this?

Thanks,

Zoltan

AnalogNotes · Accepted Answer

Well, I copied and pasted from that last message and it was a bit wonky, so I uploaded it to my web page: http://analognotes.com/eagle/pickgrouped.ulp When/if Lorenz uploads it to the Cadsoft site, I'll point to that...