I've seen and used this practical feature in an other designer system. However if I select let's say IC1 in schematic and move to the layout there is no selection for IC1 at all...
Is there any solution for this?
Thanks,
Zoltan
I've seen and used this practical feature in an other designer system. However if I select let's say IC1 in schematic and move to the layout there is no selection for IC1 at all...
Is there any solution for this?
Thanks,
Zoltan
Doesn't the 'show' button do exactly what the OP asks? With the sch and pcb editor windows both open (and in sync), click the 'show' mode button,
, then select the component you want highlighting in the schematic, it is also highlighted in the PCB.
Daniel Wainwright wrote:
Doesn't the 'show' button do exactly what the OP asks? With the sch and
pcb editor windows both open (and in sync), click the 'show' mode
button,
, then select the component you want highlighting in the schematic, it
is also highlighted in the PCB.
yes, but if you click on the "switch brd/sch" button instead using Alt+Tab
(or having both windows next to each other) the highlighting disappears 
Gruss, Matthias Dingeldein
--
Guillotinen sind nicht reziprok, aber das macht nix,
die werden eh nur fuer die Hinrichtung verwendet
Daniel Wainwright wrote:
Doesn't the 'show' button do exactly what the OP asks? With the sch and
pcb editor windows both open (and in sync), click the 'show' mode
button,
, then select the component you want highlighting in the schematic, it
is also highlighted in the PCB.
yes, but if you click on the "switch brd/sch" button instead using Alt+Tab
(or having both windows next to each other) the highlighting disappears
Gruss, Matthias Dingeldein
--
Guillotinen sind nicht reziprok, aber das macht nix,
die werden eh nur fuer die Hinrichtung verwendet
