How do i connect slightly misaligned nets?

Question

Some components don't align to the grid as they should. How can i connect them anyway?

autodeskguest · Accepted Answer

On 19/02/2014 2:17 p.m., Gerrit Bosch wrote: Thanks for your answer. It's in the schematic where the parts are not aligned in the grid. Possibly due to mixed measurement systems. mm/inch conversions. How do i fix this? -- To view any images and attachments in this post, visit: http://www.element14.com/community/message/104188 By convention the libraries are designed on a 0.1inch grid for the schematic symbols. The pins end up on that 0.1" grid. If you had your schematic set to anything other than 0.1" then you would need to get the parts back onto the grid. So I suspect the following will be your solution. Set the grid of the schematic to 0.1" Then select MOVE HOLD down the CTL key and then click on the origins of the parts. They should snap to the grid. Then you need to repair the nets that are floating. Probably easier to delete and replace them. HTH Warren