Highlite of connected points in router does not work

Question

Hi guys,

When trying to route a board manually I don't see the highlite of the opposite connected point anymore. Did I switch this off by accident? I mean the behavior on this video:

Routing Signal Trace on Eagle PCB Layout

Reagrds,

Mischa

autodeskguest · Accepted Answer

I suspect you are using the WIRE tool to route with instead of the ROUTE

tool.

A Wire will not snap to the pad and pick up the signal name and thus will

not highlight the airwire or destination pads.

HTH

Warren

--

Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.