I have had, one one or two occasions, a failure in the DRC step
where a connection on the board between two nets was not detected
(i.e. an undetected short between two nets).
The first time this occured, simply adding an unrelated trace or part
would cause the connection in error to be detected. Also editing the
.brd file and changing the order of the "<wire x1=..." lines for the affected
net would cause the connection in error to be detected (not changing the
topology or appearance of the board, simply the order of the wires listed
for the affected net).
This is with V6.5.0 (Linux) with an educational license.
Has anyone noticed this and is there a workaround?
Regards & Thanks