Cadsoft is really far behind with OSX support. So how about it?
Another vote for this topic. I've been holding off upgrading from version 6 because I can no longer use Eagle on OSX 10.10.
That's not acceptable for a piece of software I paid ~$1000 for because Apple was a supported platform.
On 8/4/2015 5:54 PM, Ian Buckley wrote:
Another vote for this topic. I've been holding off upgrading fromversion 6 because I can no longer use Eagle on OSX 10.10.That's not acceptable for a piece of software I paid ~$1000 for becauseApple was a supported platform.
Another vote for this topic. I've been holding off upgrading from
version 6 because I can no longer use Eagle on OSX 10.10.
That's not acceptable for a piece of software I paid ~$1000 for because
Apple was a supported platform.
Hi Ian,
See my above response to Anthony. Try out Beta 7.3.2, it should work
just fine under 10.10.
Let me know if it gives you any problems.
Best Regards,
Jorge Garcia
