eagle use library

Question

hello,

I want to design a supply symbol ( -3v3 ) but without use a package when I integrated it in my board , but eagle can't because it didn't had a package so anyone know how I can do ? or if there is library already do ?

Thank

MD

autodeskguest · Accepted Answer

Rob Pearce wrote on Tue, 28 April 2015 05:46 On 27/04/15 15:44, m d wrote: hello, I want to design a supply symbol ( -3v3 ) but without use a package when I integrated it in my board , but eagle can't because it didn't had a package so anyone know how I can do ? or if there is library already do ? Have you checked the "supply1" and "supply2" libraries? They provide a selection of such symbols. Granted there isn't the specific one you're after but a bit of copy-paste-edit will address that. If the pin direction of your pin in the symbol is set to SUPPLY you won't need a package. HTH Warren -- Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.

clem57 · Answer

How to create a new schematic symbol in the Eagle editor Clem

autodeskguest · Answer

On 27/04/15 15:44, m d wrote: hello, I want to design a supply symbol ( -3v3 ) but without use a package when I integrated it in my board , but eagle can't because it didn't had a package so anyone know how I can do ? or if there is library already do ? Have you checked the "supply1" and "supply2" libraries? They provide a selection of such symbols. Granted there isn't the specific one you're after but a bit of copy-paste-edit will address that.