hello,
I want to design a supply symbol ( -3v3 ) but without use a package when I integrated it in my board , but eagle can't because it didn't had a package so anyone know how I can do ? or if there is library already do ?
Thank
MD
hello,
I want to design a supply symbol ( -3v3 ) but without use a package when I integrated it in my board , but eagle can't because it didn't had a package so anyone know how I can do ? or if there is library already do ?
Thank
MD
On 27/04/15 15:44, m d wrote:
hello,
I want to design a supply symbol ( -3v3 ) but without use a package when
I integrated it in my board , but eagle can't because it didn't had a
package so anyone know how I can do ? or if there is library already do
?
Have you checked the "supply1" and "supply2" libraries? They provide a
selection of such symbols. Granted there isn't the specific one you're
after but a bit of copy-paste-edit will address that.
Rob Pearce wrote on Tue, 28 April 2015 05:46
On 27/04/15 15:44, m d wrote:
hello,
I want to design a supply symbol ( -3v3 ) but without use a
package when
I integrated it in my board , but eagle can't because it didn't
had a
package so anyone know how I can do ? or if there is library
already do
?
Have you checked the "supply1" and "supply2" libraries? They provide a
selection of such symbols. Granted there isn't the specific one you're
after but a bit of copy-paste-edit will address that.
If the pin direction of your pin in the symbol is set to SUPPLY you won't
need a package.
HTH
Warren
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
thanks CADSOFT you solve my problem
thanks CADSOFT you solve my problem
On 4/28/2015 6:54 AM, m d wrote:
thanks CADSOFT you solve my problem
Credit where credit is due. Cadsoft didn't give you the solution. Warren
and Rob did, they are very active forum members that make my job a
little easier.
Thanks for chiming in guys.
Best Regards,
Jorge Garcia
Cadsoft Support
+ Clem, sorry about that.