Default Net width

On 30.06.2016 10:16, Michael Bähr wrote:

Hello!

 

Somehow my Eagle draws Netwires with a width of 0. This is super thin, too thin. As far I can remember it should be 0.006.

 

How can I change it back to 0.006 instead of 0?

 

"Change width 0.006" in eagle.scr only sets the width for Wire not for Net.

 

I tryed some other options in eaglerc.usr like Sch.NetWireWidth="0.006" without success.

 

Does anyone have an idea?

 

Thank you.

Michael

After selecting the net tool, you pick the width before you draw. Some

nets belonging to classes may change width as you start drawing, but I

think this is not the case for you.

If you want to change existing drawn stuff, use "group" and "change width"

On 30.06.2016 10:35, Morten Leikvoll wrote:

On 30.06.2016 10:16, Michael Bähr wrote:

Hello!

 

Somehow my Eagle draws Netwires with a width of 0. This is super thin,

too thin. As far I can remember it should be 0.006.

 

How can I change it back to 0.006 instead of 0?

 

"Change width 0.006" in eagle.scr only sets the width for Wire not for

Net.

 

I tryed some other options in eaglerc.usr like

Sch.NetWireWidth="0.006" without success.

 

Does anyone have an idea?

 

Thank you.

Michael

 

After selecting the net tool, you pick the width before you draw. Some

nets belonging to classes may change width as you start drawing, but I

think this is not the case for you.

 

If you want to change existing drawn stuff, use "group" and "change width"

 

I should add, use projects. Don't just open the .sch or the .brd by

double clicking. If you start by creating a project, then always use

load project upon opening, the used widths (and other parameters) will

stay with the project. Yes, you can move your existing sch and brd to a

new project.

On 30.06.2016 10:35, Morten Leikvoll wrote:

On 30.06.2016 10:16, Michael Bähr wrote:

Hello!

 

Somehow my Eagle draws Netwires with a width of 0. This is super thin,

too thin. As far I can remember it should be 0.006.

 

How can I change it back to 0.006 instead of 0?

 

"Change width 0.006" in eagle.scr only sets the width for Wire not for

Net.

 

I tryed some other options in eaglerc.usr like

Sch.NetWireWidth="0.006" without success.

 

Does anyone have an idea?

 

Thank you.

Michael

 

After selecting the net tool, you pick the width before you draw. Some

nets belonging to classes may change width as you start drawing, but I

think this is not the case for you.

 

If you want to change existing drawn stuff, use "group" and "change width"

 

I should add, use projects. Don't just open the .sch or the .brd by

double clicking. If you start by creating a project, then always use

load project upon opening, the used widths (and other parameters) will

stay with the project. Yes, you can move your existing sch and brd to a

new project.