I am designing surface mount proto-boards. (I will upload my library once
done.) I am working ONLY in Board for this project. In my package library,
I created parts with SMD pads and through-hole pads.
I used "Signal" to name and connect some pads GND. I also have a polygon
on the solder side named GND.
I am unable to rename any of the pads that connect to GND. If I unroute
the polygon, no air-wires appear to the pads. If I use "Name" and click on
a pad, I select the nearest routed signal, not the pad. If I add a signal
from one of the pads to another net (such as VCC) I am asked to select a
name for the "combined" net. Even if I delete the polygon, I get the same
results.
In the attached file, please note the 4 holes on the top and bottom edge
of the board as examples.
Jeff Rockel
WI, USA
--
Browser access to CadSoft Support Forums at http://www.eaglecentral.ca
