Actions
Forum Thread Details
  • Replies 9 replies
  • Subscribers 177 subscribers
  • Views 727 views
  • Users 0 members are here
Related

Missing air wire

autodeskguest

I have a prety much completed board with everything routed and I forgot a connector. I have similar connectors in the schematic so I copied one of the others and placed it and made a connection to it. The second pin of the connector is ground so I copied a grond symbol from elsewhere in the schematic and connected it to the connector. On the board view only the air wire to the non-ground pin is showing. The ground pin has no air wire. All the other ground connections had air-wires before I routed them. I tried deleting the connector and starting over. The connection to ground in the schamatic appears complete becasue I can move the connector or the ground symbol and the connection follows.

I tried "redraw" on the board. No luck. If I try to put a trace on the board to make the ground connection to the connector pin it complains it cannot back annotate and it must be done on the schematic which I guess means the connection is not there.

 

So where is the connection?

 

Sage

 

 

--

Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

 

Parents

  • I agree. It has somehow become intuitive for me after figuring out what works in a particular situation and using that info to think through the next problem. I have only ever googled for solutions and found a good tutorial on making parts on the instructibles website and a few other turorials elsewhere. Now that I've stepped up from the free version to standard. Hopefully the manual when it arrives will be more handy and official insite on how I'm supposed to be using it.

    I'm actually doing quite well at it (I think)with not too much experience so I think that says someting for the program.

    I'm sure I'll have lots more questions.

     

     

    Sage

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Reply

  • I agree. It has somehow become intuitive for me after figuring out what works in a particular situation and using that info to think through the next problem. I have only ever googled for solutions and found a good tutorial on making parts on the instructibles website and a few other turorials elsewhere. Now that I've stepped up from the free version to standard. Hopefully the manual when it arrives will be more handy and official insite on how I'm supposed to be using it.

    I'm actually doing quite well at it (I think)with not too much experience so I think that says someting for the program.

    I'm sure I'll have lots more questions.

     

     

    Sage

    --

    Browser access to CadSoft Support Forums at http://www.eaglecentral.ca

     

Children
No Data