I have taken an existing Eagle design and added some components and signals to the schematic. When I go to the PCB file, which is always opened with the schematic for back annotation, the parts have been placed but there are no air wires shown from those parts. How can I fix this?
Hi Doug,
I think you mean the opposite, right? It's unfortunate naming, but the Net tool is the one that should be used, whereas the 'line' is created with the Wire tool (i.e. the tooltip calls it 'Wire'). Both will show air waves in certain conditions (i.e. when the grid is proper), however the Wire tool shouldn't be used, the Net tool is the one that's supported, Wire has some odd behaviour since it's not intended for it, (or at least it had odd behavior in old versions - don't know about new ones).
I have used the net wire
