Actions
Forum Thread Details
  • Replies 4 replies
  • Subscribers 179 subscribers
  • Views 917 views
  • Users 0 members are here
Related

Making a pad with rectangular hole in a package when creating my own part.  How?

unebonnevie

Hi,

 

I am creating a part (an SPDT switch) that an anchor pin which is 2mm wide.

When creating the package for this part, EagleCAD has pad but with circular

drill hole.  How would I make the rectangular hole, in this case, 2mmx0.5mm?

Thanks.

 

 

Parents

  • I think you should draw a rectangular on milling layer.

    of course, the pad is needed.

    I has been asked factory. generally, "if a hole on pad, they will make a

    through hole".

     

    so you should better tell the factory, where need special hole.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • I think you should draw a rectangular on milling layer.

    of course, the pad is needed.

    I has been asked factory. generally, "if a hole on pad, they will make a

    through hole".

     

    so you should better tell the factory, where need special hole.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
No Data