Actions
Forum Thread Details
  • Replies 4 replies
  • Subscribers 179 subscribers
  • Views 917 views
  • Users 0 members are here
Related

Making a pad with rectangular hole in a package when creating my own part.  How?

unebonnevie

Hi,

 

I am creating a part (an SPDT switch) that an anchor pin which is 2mm wide.

When creating the package for this part, EagleCAD has pad but with circular

drill hole.  How would I make the rectangular hole, in this case, 2mmx0.5mm?

Thanks.

 

 

Parents

  • AL wrote on Sat, 08 May 2010 05:07

    I am creating a part (an SPDT switch) that an anchor pin which is 2mm

    wide.

    When creating the package for this part, EagleCAD has pad but with

    circular

    drill hole.  How would I make the rectangular hole, in this case,

    2mmx0.5mm?

     

    Why bother?  Unless a 2mm hole would interfere with something else, just

    use that.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • AL wrote on Sat, 08 May 2010 05:07

    I am creating a part (an SPDT switch) that an anchor pin which is 2mm

    wide.

    When creating the package for this part, EagleCAD has pad but with

    circular

    drill hole.  How would I make the rectangular hole, in this case,

    2mmx0.5mm?

     

    Why bother?  Unless a 2mm hole would interfere with something else, just

    use that.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
No Data